Channel resistance thermometer

  1. Home
  2. Resistance thermometer
  3. Channel resistance thermometer
  4. Channel resistance thermometer
To the configurator

Channel resistance thermometer

Design with metal protection tube and compact plastic casing

Calculation of immersion sleeve-screw-in-length = NL (sensor) -25 mm

OPERATING CONDITIONS
TEMPERATURE LOAD

Structure:

Precision resistor single or dual, Type Pt-100 as per IEC 60751 in Tolerance class B or A, connected in 2-, 3- or 4-wire circuit from precision resistor, fit in a metal protective sleeve made of stainless steel material of diameter 5 or 6 mm and lengths between 80 and 250 mm; For better thermal coupling the precision resistors are covered with heat conducting paste. Connection box with dimensions 65*50*35 mm made of plastic with protection rating IP 65, plastic cable entry M16x1.5. It is possible to install the casing directly on a wall using two screws. A temperature transmitter with rated output signal of 4-20 mA can also be installed in the above mentioned sensor.

(For variants please refer to the worksheet).

Immersion sleeve:

Protective tube 6×0.4 mm ( 8×0.5 mm) diameter made of VA, Screw-in connector G 1/2“ made of VA with clamp connection for the sensor.

Types of wiring:

Menu